NUMECON  -  numerical  control

Supported G-codes (RS274):

G00                         Rapid Traverse
G01                         Normal Traverse
G02                         CW Arc
G03                         CCW Arc
G04                         Dwell
G17                         To select XY plane
G18                         To select XZ plane
G19                         To select YZ plane
G20                         To use inches for length units
G21                         To use millimeters for length units
G70                         To use inches for length units
G71                         To use millimeters for length units
G54                         To select coordinate system 1
G90                         Absolute distance mode
G91                         Incremental distance mode

Supported M-codes (RS274):

M00                         Program halt
M02                         End of program
M30                         End of program

Fxx                         Sets Feed Rate
Pxx                         Sets Dwell Timender construction